Moore's Law is a term attributed to Intel founder Gordon E. Moore who observed in 1965 that the number of transistors that could be purchased inexpensively and placed on an integrated-circuit doubles every year. He later revised this figure to every 2 years (1975). The doubling period is often mistakenly reported as "18 months" or shorter, this is due to being confused with the overall processing power of computers doubling at that rate because of additional factors such as increases in clock speed, increases in cache memory or improvements in chip design.
Importantly, the ability to increase the number of transistors available is due to reducing transistor size rather than increasing the size of the integrated circuit. As of 2012 the smallest commercially available transistors in a microprocessor are 22 nanometers, their 1965 equivalent were 100 micrometers (100,000 nanometers). Intel have revealed they expect to release chips with 5nm components in the near future which would continue the expected projections of Moore's law.
The End of Moore's Law?
For almost as long as there has been Moore's Law there have been commentators predicting its demise due to the supposed limitations of engineering being reached. Despite these predictions Moore's Law has proven to be extremely accurate. However, it does appear that component size does have a limiting factor in the form of the Laws of Physics. On the smallest of scales electrons become "smeared" across time and space meaning that they can no longer remain contained within the boundaries of very small components which results in disastrous contamination of processing signals.
Carbon Nanotubes would appear to address this problem, but it may be some time before a method of mass fabricating Carbon Nanotube chips is possible and even if a method is discovered these components cannot be shrunk any further due to the fixed physical limits of their structure.
If shrinking components any further becomes impossible a new form of chip will be required to extend Moore's Law. One approach would involve chips that are "stacked" into 3-dimensional layers instead of the 2-dimensional designs of today. There are a number of engineering issues that need to be addressed in order for 3D chips to be viable, the most significant of which is the issue of heat dispersal. A number of chip manufacturers including IBM have announced plans to release "stacked" chip technology.
- Gordon Moore's orignal 1965 paper Electronics, Volume 38, Number 8, April 19, 1965
- Progress in Digital Integrated Circuits Transcript of 1975 speech
- IBM announce they are developing 3D chip technology IBM press release